AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Duo cone seal installation1/26/2024 I typically use spray silicone lubricant as it leaves a dry lubricating film. You don't have to pull them excessively tight, just snug enough to hold wire in the groove.ĥ, Although it's recommended to install the seal dry, no oil or grease on the surfaces, installing the seal dry creates a lot of friction working against you. Although the edge of the seal ring isn't sharp as a knife, it's plenty sharp enough to put a nasty cut on a fingertip.Ĥ,Then join some zip ties together and gently zip them down centered on the wire to hold wire in place. It can't be a loose fit or it will allow the toric ring to walk up the ramp of the seal ring, and it can't be too tight or it will push the toric off of the seal ring, you just need a good snug fit.ģ, Work the wire around the circumference of the seal, just be careful with your fingers around the steel seal surface. I happened to find some 12 GA insulated wire that worked perfect. Always work with seal on a clean cloth and keep work equipment and area as clean and dirt/dust free as possible.Ģ, Find some automotive type insulated wire that will fit snug in the groove between the toric ring and the underside of the seal ring face. 1, Now prepare the floating seal for install.
0 Comments
Read More
Leave a Reply. |